Man, where did you learn to weld? Ground your piece properly, it's rocking like a bucking bronco.
Bill Balke21 января 2020 14:52
Also most common failures with the cut 50 : mosfets , power switch (I had that problem) , loose wires in the connectors and bad solder joints on the boards
David Lee1 сентября 2016 13:23
What a dope. First time through the 3/8" you went too fast; second time you did not have an adequate ground; third time you got lucky.
Fires Blade15 октября 2018 5:43
You should spend 229 Dollars on some more education for your self.
greggrif6627 января 2016 0:55
Clamping that 3/8 piece down would help with the ground, also slow down a little and it will cut fine.
Man, where did you learn to weld? Ground your piece properly, it's rocking like a bucking bronco.
Also most common failures with the cut 50 : mosfets , power switch (I had that problem) , loose wires in the connectors and bad solder joints on the boards
What a dope. First time through the 3/8" you went too fast; second time you did not have an adequate ground; third time you got lucky.
You should spend 229 Dollars on some more education for your self.
Clamping that 3/8 piece down would help with the ground, also slow down a little and it will cut fine.